Made a few changes 9000 brakes in front: http://i776.photobucket.com/albums/yy49/gert-jan44/2016-09-24%2011.27.58_zpsapo08q9r.jpg Made a few air intakes/outlets to get a better airflow/cooling for the engine/intercooler. Needs a bit of paint but for now it will do. http://i776.photobucket.com/albums...

Small update. Car is running good, 4th and 5th gear the turbo is a bit to small and the pressure drops at 0,7-0,8 bar. Been shopping for 16" steel wheels, found some 16", 4x108mm from Peugeot, citroën. Mounted some sticky rubber toyo proxess r888, front: 205-55-16, rear: 215-50-16 Big diff...

I've been reading the thread on saablink, very useful.

The replacement speedometer sender seems like a good solution.
Thanks for the reply's!!

Ok thanks for the reactions,
I gues I will give it a try without the speedsignal.

Hi all, I have a question about trionic 5 conversions. I would like to switch to trionic 5 but keep the original 99 dash. Problem: the 99 dash has no speed signal output. Some say you can make selections in T5suites to run without speedsignal , some say the car will only run on baseboost. I have the...

That's awsome!
Keep on going

the Intercooler hose wase blown off at 1,1-1,2 bar

Car is running good now! I'm using a standard 900 160hp APC box, peaks about 0,9bar and goes down to 0,7bar. It's a safe setup. Last week I blown off the intercooler hose. Verry scary! I tought I've blown the head gasket... After a quick fix it was back running! Had a few issues with the ignition co...

oké thanks, I will try to fit it then...

Hi all,

I have a question about the ELCD valve, is it better to connect it or can I just leave it out?
In a few online topics they say that it influences the air/fuel mixture?

Thanks!
Gert-Jan

Found it and now it's out of the way!

Is here anyone who knows if the Lucas CU14 management system has a fuel cut off switch?

I can't find it on any wiring schedule... but I think there should be one? no?:)

don't mind the engine mount, it was a prototype;)

Hi, I only have 1 pic of the firewall modifications. I first test fitted the engine and marked the place where the crankshaft pulley and waterpump pulley. In the picture you maybe can take some reference points from the heater? It's about 3cm deep into the interior. http://i776.photobucket.com/album...

Hi, I'm currently rebuilding my 99 to a 16v Turbo. Until a few weeks back it was running on a NA 16v enigine witch was mounted on the original 4 speed gearbox. I would like to give you guys and girls a look at what I'm doining and maybe I can ask a few questions ;) the first NA 16v engine (old pictu...