Installing requires cutting/removal of the cubby under the bolster and modifications to the center console.

I hate to to do this but I'd like to put the interior back to stock in my road car. Selling this beautiful shifter made by Luke Sorenson. I'd guess there is less than 1000 miles on it. - Shifter - Shift rod with universal joints (one of the dust covers could be replaced) - Asking $500 plus shipping/...

Broke one of the electrical tabs on my starter solenoid... Please PM me with details. Prefer OEM Bosch.

Looking for parts for a flat front conversion:

1. E-codes (I have like new slant nose e-codes to trade if interested)
2. Corner lights + pigtails/rubber boots
3. Grille
4. Front/rear bumpers
5. SPG/turbo lower air dam

Please message me with details.

I'm having trouble understanding what you are describing and what you are trying to solve. Air bubble rise to vent to atmosphere, so yes waterline above the highest ingesting point's waterline. Basically asking what you already answered. The design of the current reservoir has the inlet port from t...

Trying to decide if my reservoir design will work properly... I have the larger port roughly halfway up the side of the tank facing towards the water pump. In order to keep air out of the system, does that mean I will always have to keep coolant filled above this minimum line? https://c1.staticflick...

Deka ETX18L, period.

Made in Pennsylvania!

Luke,

What relays are used in your wiring design?

The stock T5 relays look like changeover relays not dual output.

At this point probably won't be making a mold. Focus needs to be on getting the car running and driving.

I may in the future consider making a mold/repros when time allows.

Got the trunk from the parts car installed. This one came off an N/A car with no spoiler. Mocked up and got the holes drilled for the rally spoiler. https://c2.staticflickr.com/6/5612/29966446062_4391e3b629_b.jpg https://c2.staticflickr.com/8/7520/29785633440_c9cc616fec_b.jpg

The heat shrink will work if pulls down to the wire pair of expando braid diameter. Also I had the braid melt as I tried to shrink with too much heat. You can add a short section in smaller dia to add bulk and shink over it. You can get replacement boot here. 4$ each. The have different sizes to ma...

It is a lot of work. Some suggestions: Looking at you AMP junior timers, you should add a boot for sealing and strain relief. At the big ECU connector, wrap self vulcanizing silicone tape around the bundle and zip tie the works to the connector's "neck". Strain relief to reduce the chance...

Update time. Finally finished my harness build, quite the process from scratch. Now to do the rest of the car! https://c1.staticflickr.com/9/8003/29213031513_48afea1660_b.jpg https://c1.staticflickr.com/9/8661/29839109555_0716e6eb8a_b.jpg https://c1.staticflickr.com/9/8147/29726027932_6b176f1e75_b.j...

My 2 cents...

If you have a laptop with T5 suite the OBD connector seems like a bit of a redundancy. I decided to leave this off my harness build.

Name:Jonathan Location: San Jose, CA Means of contact: PM Price: SOLD Description: Protective film is covering the logos, these are BRAND NEW. Pictures: https://c1.staticflickr.com/9/8758/27719821423_549fed3a5d_b.jpg https://c1.staticflickr.com/9/8631/28301782356_91b4603964_c.jpg