Hey all!
I'm going to use the long weekend to rebuild the dash on my 85 SPG.
While I'm in there, I need to replace the heater valve.
I have a couple of rebuildable (needs new O rings) plastic valves and a NOS metal valve. I know the metal can get stiff and crack the rod, but is there any advantage one over the other?
I have an uncracked dash, and a very nice bezel to use and I don't want to have to do this again.
John
Metal vs. Plastic heater valve
-
- Posts: 64
- Joined: Sat Jul 06, 2013 6:49 am
- Nickname: Jeff
- Number of Saabs currently owned: 3
Re: Metal vs. Plastic heater valve
I used a new ScanTec plastic valve. However I found the mating surface around the o rings was not flat so I corrected it on my belt sander. 2 years later still sealed up.
Who is online
Users browsing this forum: No registered users and 6 guests