NEEDED: 2 good 81-87(base) C900 front hubs

[firedome]

preferably in VT or upstate NY or near-ish PA area for pickup! To replace the front hubs on our '77 99.

We go up to VT via I-87 thru Glens Falls/Queensbury/Ft Ann fairly regularly.

Please advise and thanks!
Roger A
Binghamton NY

[SwedeSport]

I may have hubs and spindles.

Probably will need wheel bearings.

I'm in PA near Philly.

[DeLorean]

There is or was one at Garrys U pull it in Binghamton NY as of about 2 months ago. It may be gone by now. Might want to check that out though being that it's probably within walking distance for you.

[87 n/a]

FYI, the pre-88 900 steering knuckles will fit in a large flat rate box from the post office. 1 per box.
Much better than shipping by weight

[DeLorean]

depends where. Zone 1 probably not. Anywhere else, yes. Zone 5 you will get em for probably $30

[firedome]

Went to Gary's last month and today... no C900s at all. Been thin on the ground lately.

Josh & I live in Endwell (different houses) about 3 mi W of Bingo and 8 mi from Garys.

There's a '80 EMS in another yard nearby (or was last time there) but i'ts been sitting on the ground for decades, probably toast underneath. Has the dual slot hood but it's pretty rusty.

I may have to take the one's off Josh's 84 900T and help him buy a vented setup! LOL

[burnsside42]

I have both complete front assemblies with axles and all and cross drilled rotors. I believe they are from an 87 c900 - I will have to check. It's in my dad's basement. Next time I am there I have to pick up my "sold" 9000 transmission. I may just grab the hub assemblies too if I got room. If they are newer 88+ I know a car which could benefit from the rotors...