Adjustable Cam gears

[DrewP]

So far I've had requests from these people in order:

-Luke
-Tsmall
-Jon1
-gmreider

-Neil_G
-Crazyswede
-iceman_ca
-vintagesaabs


Anyone else, or did any of you 7 change your minds?


I'm going to pick up the machining fixtures and get the programs formatted for our CNC equipment and order the rest of the missing parts.

[gmreider]

I'm still in for sure. gmreider

[vintagesaabs]

Drew,
Please add me to your tally.
Bob Dorste Portland, OR.

[iceman_ca]

Still in

[Neil_G]

Yes, still in

[DrewP]

Got you Bob, thanks.

[Jon1]

Still in, would take two sets, if available.
thanks

[Crazyswede]

committed

[DrewP]

I had forgotten the price from the original run, it was $300, in case that turns anyone off. Sorry for mixing it up.

I got parts and machining fixtures over the weekend, and ordered the stuff I was missing. I'll make a new thread for updates.

In case anyone wants to check it out, original thread is here: viewtopic.php?f=11&t=2219

[gmreider]

I'm still in, but maybe you could have them engraved with the Drew P Logo to enhance the value?

[DrewP]

HAHAHA, I'll think about it.

[Crazyswede]

Droopy

[Nate]

Drew,

Are you just finishing the 4 you have or are you doing an entire new "fresh run"?

[DrewP]

I will make enough that everyone who expresses interest can have a set, the first batch of 4 pairs I'll probably have done sooner though.

Right now I am planning on making 12 pairs so there are some extras for people who might not have seen this thread yet.

[Jon1]

I am still in, thanks Drew. (two sets, if possible)