Finally made a fiberglass hood mold

[99Super]

A co-worker had all the proper stuff to make a mold but he wasn't getting around to it and the resin was coming up against the expiration date so we made a mold of a hood...

The time lapse...
http://www.youtube.com/watch?v=fgKSlj-0zhw
Now to get the hood made!


John

[squaab99t]

A co-worker had all the proper stuff to make a mold but he wasn't getting around to it and the resin was coming up against the expiration date so we made a mold of a hood...

FiberHood.jpg

The time lapse...
http://www.youtube.com/watch?v=fgKSlj-0zhw
Now to get the hood made!


John

So not to be slamming the effort, but I did not see a tooling gel coat laid down or run out area past the trim line. The gel coat is important so you can see you have proper coverage on your finish part. The runout helps the cloth drape past the trim line so the plys do not pull apart and create voids in the part.