900 rear Upper Spring Supports
-
- Posts: 12
- Joined: Sat May 05, 2012 11:09 pm
- Nickname: Buttercup
- Number of Saabs currently owned: 2
900 rear Upper Spring Supports
This is for my 1988 900 SPG. It is a street car that sees a lot of backroad driving but is not a rally car nor will it be. I sort of hate to muddy up this forum with a general question -- but the rear spring supports (upper, I think you'll refer to these as spring "perch") are bending due to corrosion (on the carbody/vertical adjacent the spring support if that makes sense) and I'm taking the car over to a welder on Monday to have new supports fabricated. Besides just beefing up the plate and doing a good job tying in with the car body, I'm not sure what else may be done. Since this is not a rally car and there's no additional cage/body support going into it, I'm wondering if there is anything that should be done differently? Has a member here done anything with design of rear upper spring perch for the 900? Thanks! so much.
- Crazyswede
- Team Turbo Troll Crew
- Posts: 4540
- Joined: Fri Sep 22, 2006 3:53 pm
- Nickname: Mongo
- Number of Saabs currently owned: 97
- Location: Vermont
- Contact:
Re: 900 rear Upper Spring Supports
its not a common area that I've seen rust problems in and its for a spring where the impulse forces are low. I'd just cut out the rust and corrosion and weld in some new solid metal and seal it and should be good.
I am the 73%
-
- Posts: 12
- Joined: Sat May 05, 2012 11:09 pm
- Nickname: Buttercup
- Number of Saabs currently owned: 2
Re: 900 rear Upper Spring Supports
Thanks for your reply. We did end up having a welder do exactly as you suggested.
Return to “SAAB MOTORSPORT TECH”
Who is online
Users browsing this forum: No registered users and 5 guests